But don't take my word, check the numbers for yourself. The Mits RPTV might not be to happy about that. Mtrot.unless something unforseen takes place, I would take the silver and part with the 570. It looks as if the Silver is ahead by 2.5 paces. Just checked the spec between the Paradigm and Silver, just out of curiosity. It bares more weight and has more effect on the entire system than you think. However, it really isn't the main point though. Room shake is just a added bonus to a strong sub. I was close to spending the $2500 for a Def Tec setup. I had the same misconseption about a sub and/or front-sub combo system. "But they do shake the room pretty good if you turn it up. But, keep in mind you will be selling you system short though. If the band-aid approach works for now, although it wouldn't be my first choice of approaches, then do what works for you. Since there are certain limitations holding you back, I can see how you've focused on just the settings and not the overall setup. If you fix things early instead of slapping a band-aid on it, you're gonna be much better off. Setting the center to small may work fine for you for now, but once seen and heard how sub intergration really effects the overall performance.if you haven't already, there's a good chance you gonna want to change. This is part of the reason why attention should be paid to speaker selection. Mtrot.I think what D Edwards is getting at is that what your focusing on is just a temporary solution to a situation that should really bring the best out of your setup. The critical part is making sure your speakers and sub(s) are coupled well (and flat ideally) at the crossover frequency, and in phase! Here in lies the problem where most people run into with speaker/sub placement and setup. So, the vast majority of the time (I've yet to run any center speaker as large in any setup I've ever done, and I've done hundreds!), you get better efficiency, and dynamic range from crossing over to "small". (some larger horn speakers help greatly). And most speakers aren't so "sensitive" as well. Basically, not only does the speaker have to play lower than comfortable often, when set to "larger" (or anything larger than 60-80hz really), but the amps (usually receivers) can't really control the drivers well enough in most passive crossover design models either! The passive crossover is a rather innefficient design overall. Another case, and just as important of one, is that these passive speakers can't properly deal with full range bass info efficiently enough, often leading to distrotion, clipping, and squashed dynamics. Yeah, except when a speaker (in this case, center speaker) is sitting in somewhat of a hole in the 70-80hz regigion, and someone ends up getting some more "umph" by crossing their rather large center speaker over at, like 60hz or whatever, you should most always be looking at crossing over a normal sized center speaker at "small"! Why? Yes, they don't play so low.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |